If you’ve never used a sealant before, don’t fret – CT1 sealant and adhesive is a simple and effective way to get a fantastic finish on any DIY project. It’s perfect for use in the home as it’s non-toxic, doesn’t contain any solvents, and has excellent colour retention. So, whether you’re trying your hand at resealing your bathtub or repairing a leak, CT1 is the fast, user-friendly way to get a great result.
How to prepare CT1 for use
CT1 sealant and adhesive can give you a great, professional-looking finish on a wide variety of projects, but preparation is key to achieving this. To prepare your CT1 for application, you need to first cut the nozzle on the tube to the correct size using a sharp utility knife. This will determine the size of your bead.
If you want a small bead of sealant, you will need to cautiously cut a very small amount of the nozzle off. If you want a larger bead, then you can cut further down the nozzle. Be conservative, if you’re not sure how big you want your bead to be, try a smaller size first – you can always add more later.
To get a very small bead, a top tip is to just shave off some of the plastic at the end of the nozzle. The nozzle should still be completely sealed, but the plastic will be thinner. Then take a pin or a thumbtack and pierce a hole at the end of the nozzle. This will give you the smallest possible bead for an extra precise application.
When cutting the nozzle, make sure to do it at a 45-degree angle. This ensures an easy application as your nozzle will neatly fit into any groove. Another top tip is to create a bevel by shaving off the edges of the plastic surrounding the hole. Then remove any overhanging plastic at the sharpest point of your cut. This way, when you distribute your bead, the plastic won’t interfere with your finish.
How to apply CT1 sealant and adhesive
Applying CT1 sealant and adhesive is very straightforward. Simply load the prepared cartridge into your caulking gun and squeeze down on the trigger to start applying CT1. Usually, sealant is applied evenly in a straight line, so apply consistent pressure to the trigger as you drag the nozzle along your desired application area.
Once you’ve applied your bead of CT1 along your desired area, use a wet finger to press the sealant into the groove. Firmly smooth your finger along the length of the sealant, in a similar motion to how you first applied the CT1. CT1 is completely non-toxic, so all you need to clean up afterwards is a damp cloth. Then leave it to cure. CT1 cures quickly but depending on how thick your application, you may have to wait longer before it’s fully cured.
CT1 can be used for a wide range of applications in the home including many DIY projects. So, if you’re ready to start using CT1 in your home, purchase CT1 from online retailer, ToolStation.