Tanking Wet Walls with WT1: A How-to Guide

Tanking wet walls is a necessary precaution to take when it comes to walls that experience a great deal of moisture and dampness. The traditional method of tanking wet walls was to batten the inner surface of the wall and then panel over it. Back then, this method was only a short-term solution. After time, people noticed that the panelling (If it was wooden) would begin to dampen and eventually rot. With the advancement of technology, came a new and far more effective solution for tanking wet walls. This was to coat the wall with a waterproof barrier to stop the dampness from penetrating the inner surface of the wall.

WT1 – The ultimate tanking solution

Liquid bitumen coating is effective but incredibly difficult to apply, particularly when it comes to masonry. The reason for this is because tradition bitumen based membranes are prone to separating itself from the wall because it has failed to cure properly. The best way to avoid this, is to use a more effective and stronger alternative.

WT1 has been named by professionals as the “ultimate replacement for bitumen based membranes”. It takes away the difficulty of applying a waterproof membrane and provides a seamless application to a variety of surfaces including stone, lead, brick and concrete (to name but a few). WT1 is 100% waterproof and acts as a stable and reliable barrier, preventing dampness from getting into the walls.

Damp walls can lead to serious problems such as mould growth, which can cause a variety of health issues. The most common of which includes allergies such as itchy eyes, runny noses and skin rashes etc. This is even more serious in homes where people are more susceptible to developing such problems such as those with asthma and with skin conditions.

Mould Growth Prevention

WT1 fights against all of these problems. It’s the perfect solution to prevent mould growth from occurring in the home. Tanking walls is made easy thanks to the simplicity and power of this product. Applying WT1 to walls can be achieved by spreading it on the surface, brushing it or even by spraying. The surface must be as dry as possible, so make sure that there is no active water seeping from the wall before application. A clean surface is also necessary. Remove dust paint, old plaster and any loose debris that may be present before you start to apply WT1 onto the walls surface. This makes your job a lot easier and allows WT1 to get to work faster.

When it comes to tanking wet walls in the home, there is no better choice than WT1. This is the ultimate waterproofed membrane and a product that you can trust to get the job done. Tanking damp walls should be your top priority as a home-owner, both for the safety of your home and the health of those living inside.

WT1 – The Ultimate Waterproof Membrane for Tanking Wet Walls

" "
istanbul escortistanbul escortistanbul escortistanbul escortistanbul escortistanbul escort
istanbul escortistanbul escortistanbul escortistanbul escortistanbul escortistanbul escort
istanbul escortistanbul escortistanbul escort istanbul escortistanbul escortistanbul escort